This is the main content.
Victor Battery Booster Cables, 8 Foot
Victor Battery Booster Cables, 8 Foot
{{ slotProps.actionTitle }}
Product details Specs: copper wire & clamps; 10 gauge wire; 150 amp capacity. Performance guaranteed. King of the road for over 50 years. www.bellautomotive.com. www.victor-automotive.com. Made in China.

Warning

Caution: Batteries produce explosive gases. Wear safety glasses when using booster cables. Explosion hazard from improper cable connection. Always use protective eyewear. Do not smoke or use open flame near battery. Remove vent caps before jump-starting to check liquid level. If liquid is not visible or is frozen, do not attempt to jump-start. Replace vent caps and cover vent openings of both batteries with rags and shield eyes. Only connect batteries of like voltage. Avoid contact with lead-acid batteries containing sulfuric acid. In case of contact with eyes, flush with water for 15 minutes. If swallowed, drink large amount of water or milk and contact physician immediately. This product contains chemicals, including lead, known to the State of California to cause cancer, birth defects or other reproductive harm. Wash hands after handling.

Additional info
Instructions (Consult your car owner's manual for complete instructions): 1. Connect one clamp to dead battery terminal wired to starter or solenoid at positive post. 2. Connect the other end of the cable with same color-coded clamp to the positive post of the good battery. 3. Connect after clamp to negative post of the good battery. 4. Connect remaining clamp to engine block of stalled car as far away from the battery as possible. 5. Start car and immediately remove clamps, reversing procedure by removing clamp on engine block first.